How To Sleep A Target Alarm Temporarily; How To Deactivate A Target Alarm; How To Select The Target Strength Which Triggers A Target Alarm; How To Turn The Buzzer On/Off - Furuno FR-10 Operator's Manual

2.22.4

How to sleep a target alarm temporarily

When you do not require a target alarm temporarily, you can sleep the target alarm.
The alarm zone remains on the screen, but any targets that enter (or exit) the alarm
zone do not trigger the audio and visual alarms.
1. Press the TARGET ALARM key to select the ALARM 1 or ALARM 2 indication at
the upper-right corner on the screen. The selected indication is in a rectangle.
2. Press the CANCEL/HL OFF key. The alarm zone is now slept.
To reactivate a sleeping target alarm zone, press the TARGET ALARM key to select
the required alarm, then press the ENTER key.
2.22.5

How to deactivate a target alarm

1. Press the TARGET ALARM key to select the ALARM 1 or ALARM 2 indication at
the upper-right corner on the screen. The selected indication is in a rectangle.
2. Press the MENU key.
3. Press the TARGET ALARM key. The alarm indication is shown in a blue.
4. Press the MENU key. The target alarm zone and the alarm indication are erased
from the screen.
2.22.6

How to select the target strength which triggers a target alarm

You can select the target strength which triggers the target alarm as follows:
1. Press the MENU key to open the menu.
2. Press  or  to select [Alert Settings], then press the ENTER key.
3. Press  or  to select [Alarm Level], then press the ENTER key.
4. Press  or  to select the echo strength level, among [Low], [Middle] and [High].
5. Press the ENTER key followed by the MENU key.
2.22.7

How to turn the buzzer on/off

You can turn on/off the panel buzzer or external buzzer for target alarms. The panel
buzzer is for this equipment. The external buzzer is for the optional buzzer, which is
connected to this equipment to give the target alarm at a remote location.
1. Press the MENU key to open the menu.
2. Press  or  to select [Alert Settings], then press the ENTER key.
3. Press  or  to select [Panel Buzzer] (or [External Buzzer] for optional buzzer),
then press the ENTER key.
4. Press  or  to select [On] or [Off] then press the ENTER key.
5. Press the MENU key to close the menu.
2. OPERATION
2-27