Display Unit
12 VDC
Display
Power
Mounting
Cable
Bracket
Transom Mounted Transducer
or
Thru-Hull Transducer
Getting Started
Check to see that all the components shown at left were
included with your Sea Scout. If a part is missing, contact the
Interphase Customer Service Department (831) 477-4944
immediately.
WARNING: DO NOT operate the Sea Scout with parts
missing or with parts other than those obtained through
Interphase; doing so could cause a malfunction in the unit.
Any malfunctions to the Sea Scout resulting from
unauthorized parts are not covered by warranty.
Turning the Sea Scout On
To turn the Sea Scout on, press the Power/Backlight Key
located on the lower right corner of the unit one time. The unit
should sound a beep and the display should be illuminated.
Mounting
Knobs
The Control Center
From the Contol Center the Contrast can be adjusted by
turning the Control Knob cockwise to darken, counter
clockwise to lighten. Seven of the most popular displays have
been pre-programmed into the Sea Scout's memory and can be
instantly selected from the Control Center Menu. In the
following sections, these different displays are called "Views".
They include:
♦
Full Screen Forward View
♦
Full Screen Track Plot View
♦
Full Screen Chart (Conventional) View
♦
Full Screen Set-Up View
♦
Split Screen Data View with Large Digits on left and
Forward looking display on right.
♦
Split Screen View with Chart (Conventional) display on
left and Forward looking display on right.
♦
Split Screen View with Chart (Conventional) display on
left and Track Plot display on right.
Each of these views can be easily selected by pressing the
button below the desired menu selection. Where two
selections are possible, press the button again until you see
your desired view. When first turned on, the Sea Scout's
internal memory automatically sets the starting view to the last
one you used before turning off the power.
The flow chart diagram on the facing page shows how to easily
navigate between the Sea Scout's instant Views.
22