Maintenance And Factory Reset - Interphase Sea Scout Operation Manual

Maintenance
The Sea Scout Forward Scanning Sonar has been designed to provide reliable, trouble-free performance for years.
Follow the maintenance tips below to ensure that your Sea Scout remains problem free.
1) Keep your Sea Scout clean and dry. Occasionally wipe unit off with a damp cloth, but be careful not to scratch
the lens covering the LCD screen. For stubborn dirt, use a mild soap and a damp cloth. NEVER USE SOLVENTS
SUCH AS PAINT THINNER, ACETONE, OR GASOLINE TO CLEAN YOUR Sea Scout.
2) Occasionally clean the face of the depth transducer (sensing surface) and carefully remove any marine growth.
Use a mild detergent, or 220 grit sandpaper, or crocus cloth to remove stubborn growth.
3) If the in-line fuse is blown, replace it with a 2 amp fuse. NEVER REPLACE WITH A HIGHER AMP RATING!
If the fuse continues to blow, check the polarity of your 12 VDC power source. If the polarity is correct, check with
the Technical Service Department at (831) 477-4944.
4) In order to protect your transducer from water damage, paint it with one of the following brands: Interlux-
UltraCoat, Fiberglass Bottom Coat, Super Bottom Coat; Pettit-UniPoxy; Rule-Super KL, Gloss Dura Poxy. DO NOT
use a solvent based paint.
5) DO NOT allow any solvents, i.e. gasoline, acetone, to come in contact with the transducer or head unit as
these may dissolve the material.
Factory Reset
Doing a factory reset as described below will return your Probe to the original faxtory settings (range, gain,
display, etc.).
Start with the unit off.
1. Press soft keys #4 and #5 and hold (as labeled in diagram below)
2. Press the #6 key.
The unit will turn on and beep three times, then release the keys. The units logo should appear in the display. This
will reset the unit to it's 'factory settings', please refer to the set-up view portion in the Operations Manual if you
wish to choose a language, select units or modify the level/alignment.
LCD Display
#1 #2 #3 #4 #5 #6
Hold these keys as
power key turned on
50
Power Key