Set-Up View; Demo Program; Units Of Measure - Interphase Sea Scout Operation Manual

Set-Up View

The Sea Scout includes a SET-UP View where the
DEMO program can be activated, the units of measure
and language can be selected and the display contrast can
be adjusted. The Sea Scout s internal backup battery will
remember all settings for future use.
From the Control Center press the button below the
SET-UP soft key twice to put the display into the SET-
UP View. Then press the button below the "GO" soft key
to use this view. The display should appear as on the
right.

Demo Program

We highly recommend you initially operate the Sea Scout
in the DEMO mode to familiarize yourself with the many
advanced features of the Sea Scout. When using the
SET-UP view, press the soft key below DEMO and hold
for 3 seconds to activate the simulation program. The unit
will automatically cycle through a simulated
demonstration of its many features. At any time, you can
press any key to gain control of the DEMO program to
make your own selections and adjustments. If you do not
press any button for about 45 seconds, the unit will
automatically resume cycling through the different demo
features on its own.
The pictures shown in the DEMO mode are
representations of what you might see on your Sea Scout.
In actual use the picture you will get can vary significantly
depending on depth, bottom and water conditions, the
speed of your boat and many other factors (see
Interpreting The Sea Scout's Forward Display, page 44).
To exit the DEMO program either turn the Sea Scout off
and back on again, or press the "DEMO" soft key again.
Select Units of Measure
The Sea Scout starts with the last units of measure
selected. By pressing the button indicated on the display,
you can use the large front panel knob labeled "BEAM" to
choose between U.S., Nautical and Metric units. Rotate
the front panel knob to select (highlight) the type of
s
display units desired. Once elected, press any button to
save your selection and exit. The current choice is
displayed each time the "UNITS" soft key is pressed.
24