Hold 'N' Go" Function; Electrified Dual Clutch Automatic Transmission - Alfa Romeo Tonale Owner's Handbook Manual

remember to always have your electronic
key with you.
114) The electric parking brake must always
be engaged when leaving the car.

"HOLD 'N' GO" FUNCTION

(where provided)
The car can be equipped with the "Hold
'N' Go" function, which automatically
engages the electric parking brake
when the car is stationary and the
ignition device is in the START position.
This allows the driver to keep the car
stationary without pressing the brake
pedal while stopping the engine.
With the "Hold 'N' Go" function activated
and the car stationary, pressing the
accelerator pedal automatically releases
the parking brake.
The "Hold 'N' Go" function can be
deactivated via the instrument panel
display settings. For more information,
refer to the "Display" chapter in the
"Knowing the instrument panel" section.
115)
WARNING
115) RISK OF ACCIDENT! Hold 'N' Go does
not replace the parking brake when parking.
When parking, it is imperative to apply
the parking brake before leaving the car
146
or ensure the automatic parking brake
is applied, if activated using the Alfa
Connect system settings. The warning light
or symbol on the instrument panel
switches on to signal that the parking brake
has stopped.
ELECTRIFIED DUAL CLUTCH
AUTOMATIC TRANSMISSION
(Mild Hybrid versions)
DISPLAY
The display can show the following:
in automatic driving mode the
selected gear (P, R, N, D)
in sequential driving mode, the
manual engagement of a (higher or lower)
gear showing the corresponding number
ELECTRIC MOTOR ("e-machine")
The transmission is mechanically
connected with a synchronous electric
motor with 48V double three-phase
winding.
The functions of the electric motor are:
to provide additional torque to
the transmission, optimising the
performance of the heat engine
recover kinetic energy when braking,
converting it into electric energy
(generator function), which can be used
for drive or to power the electric loads in
the car
to allow the car to be driven in electric-
only mode
to start the heat engine while the
vehicle is moving
GEAR LEVER
The gear lever fig. 147 has the following
positions:
P = Park
R = Reverse
N = Neutral
D = Drive, (automatic forward speed)
"AutoStick":
"+" shifting to a higher gear in
sequential driving mode
"–" shifting to a lower gear in
sequential driving mode
147
To select the "sequential" mode, shift
the gear lever from D (Drive) towards
the left. The reachable positions are
+ (higher gear) or - (lower gear). These
9650179