Alfa Romeo Tonale Owner's Handbook Manual page 155

152
1
153
Press the button (1) fig. 152 to deactivate
the Speed Limiter and activate Adaptive
Cruise Control, and vice versa. If one of
the two functions is activated when the
ignition device is in the STOP position, it
will remain activated when the ignition
device is returned to the ENGINE
position.
By turning the ring (2) ring towards SET
+ or SET - (first position of the ring) for a
very short time, the set speed increases
or decreases by 1 km/h. Each turn of the
ring will increase or decrease the speed
by 1 km/h. By keeping the ring in the
SET + or SET - position, the set speed
increases or decreases in proportion to
the time the stalk is held in that position.
By turning the ring (2) ring towards SET
++ or SET -- (second position of the ring)
for a very short time, the set speed
increases or decreases by 10 km/h. Each
turn of the ring will increase or decrease
9650114
the speed by 10 km/h. By keeping the ring
in the SET ++ or SET -- position, the
set speed increases or decreases in
proportion to the time the lever is held in
that position.
With Speed Limiter ready (symbol (1)
fig. 153 white), setting the speed with the
speed limiter ring (2) the Speed Limiter
is activated and the symbol turns green
together with the speed value shown
alongside.
9650104
The functions of the steering wheel
buttons are as follows:
RES (where provided): device
activation. The activation of the device is
signalled by the display of the symbol (1)
fig. 153 and the set speed on the green
display
CANC (where provided): device
deactivation (deactivation of the device
is indicated by the symbol (1) fig. 153 that
appears white and in brackets on the
display
RES/CANC (where provided, in the
absence of the RES and CANC buttons):
if the system is not active, pressing
the button will recall the last speed
set previously; if the system is active,
pressing the button will deactivate the
device
EXCEEDING THE PROGRAMMED SPEED
By fully depressing the accelerator
pedal, the programmed speed can be
exceeded even with the device active
(e.g. in the event of overtaking).
The device is disabled until the speed
drops below the set limit, after which it
reactivates automatically.
While driving at a higher speed than
previously set, the limit can be updated
by turning the ring towards SET + or SET
- (2) towards SET + or SET -. By turning
the ring to the SET++ or SET -- position,
the speed will be rounded to a larger
multiple of the current speed of the car.
Automatic off of the device
The device deactivates automatically in
the event of fault in the system. In this
case, contact an Alfa Romeo Dealership.
153