Alfa Romeo Tonale Owner's Handbook Manual page 34

DIPPED BEAM HEADLIGHTS
With the ignition device on ENGINE, turn
the switch to . If the dipped beam
headlights are activated, the daytime
lights are switched off and the dipped
beam headlights, side lights and number
plate lights are switched on.
The warning light switches on in the
instrument panel.
DAYTIME RUNNING LIGHTS (DRL)
"Daytime Running Lights"
27) 28)
The daytime running lights (DRL) are
activated with the ring in position
in daylight conditions. They remain off
as long as the electric parking brake is
engaged or the transmission is in the P
(Parking) position. With the ignition
device in the ENGINE position and the
heat engine switched off, the daytime
running lights are off. The daytime
running lights are also temporarily
deactivated when the direction
indicators are activated. When the
direction indicators are deactivated, the
daylight running lights are reactivated.
In some versions, if one of the daytime
running lights fails, all the daytime
running lights on the side where the
failure is present are switched off.
32
REAR FOG LIGHT
The rear fog light switch is integrated
with the light switch.
With ignition device in the ENGINE
position, press button
light on/off.
The rear fog light switches on only when
the dipped headlights are on. The light
can be switched off by pressing the
button again or by switching off the
dipped beam headlights.
PARKING LIGHTS
These can be turned on by turning the
and
light switch ring to the
The warning light switches on in the
instrument panel.
WARNING Do not select this light switch
position when the car is moving, but only
to indicate that the car is parked when
prescribed by the regulations in force
in the country where you are driving
(Highway Code).
TAIL LIGHTS
The tails on the tailgate are switched off
when the door is opened.
HEADLIGHTS OFF TIMER
This safety function delays the switching
off of the headlights, allowing the space
in front of the car to be illuminated for a
certain period of time.
Function activation
With the ignition device turned to STOP
or removed, pull the left stalk towards
the steering wheel within 2 minutes from
when the ignition device is turned to the
to switch the
STOP position.
Each time the stalk is moved, the lights
stay on for an extra 30 seconds up to a
maximum of 210 seconds; then the lights
are switched off automatically.
Furthermore, the symbol
instrument panel lights up whenever the
stalk is operated. The display shows
a message and the time set for the
position.
function.
The symbol comes on when the stalk
is first moved and stays on until the
function is automatically deactivated.
Each movement of the stalk only
increases the amount of time the lights
stay on.
Function deactivation
Hold the stalk pulled towards the
steering wheel for more than 2 seconds
or turn the ignition device to the ENGINE
position.
If the headlights are switched off before
the ignition, they will switch off normally.
MAIN BEAM HEADLIGHTS
To activate the fixed main beam
headlights, with the ignition device in
ENGINE, push left lever fig. 39 (car travel
direction) into unstable position. The
on the