Alfa Romeo Tonale Owner's Handbook Manual page 210

210
open the tailgate and then remove the
load platform
remove the fixing device for the jack
and the space-saver wheel (where
provided). Remove the wheel locking
wedge (where provided)
remove the jack unit and the wrench
for removing the fixing bolts from the
space-saver wheel . Turn the screw of the
jack to loosen the wrench and separate it
from the jack assembly
extract the space-saver wheel from
the boot
The following are inside the tool
compartment under the boot fig. 211:
1: the jack
2: the screwdriver
3: the emergency refuelling adaptor
4: the wheel locating pin (where
provided, to use during the space-saver
wheel fitting operation)
208
5: special tamper-proof nut (where
provided, to be used for fitting/removing
wheel studs)
6: a chock for locking the wheels
7: the tow ring
8: the wrench for removing/tightening
the wheel fastening bolts and operating
the jack
Then proceed as follows:
9650188
should it be necessary to stop the car
on a road with a gradient, especially a
very steep one, or on an unstable surface,
take wedge (1) (where provided) and fold
it out, as shown in the diagram in fig. 212
211
212
then position the wedge (where
provided) or a stone at the rear, on the
wheel diagonally opposite the wheel to
be replaced fig. 213 so as to prevent
unwanted movement of the car when it is
raised off the ground
213
Jack warning label
9650231
214
9650232
9650233
5520120D