Table of Contents
Advertisement
34
GETTING TO KNOW YOUR VEHICLE
WARNING!
•
For vehicles equipped with Keyless Enter 'n Go™
Ignition, always remember to place the ignition in
the OFF position when exiting the vehicle.
Duplication of key fobs may be performed at an autho-
rized dealer. This procedure consists of programming a
blank key fob to the vehicle electronics. A blank key fob
is one that has never been programmed.
NOTE:
•
When having the Sentry Key Immobilizer system
serviced, bring all vehicle keys with you to an autho-
rized dealer.
•
Keys must be ordered to the correct key cut to
match the vehicle locks.
•
It is not mandatory to replace the key fob if a new
emergency key is needed, and vice versa.
SENTRY KEY
The Sentry Key Immobilizer system prevents unauthor-
ized vehicle operation by disabling the engine. The sys-
tem does not need to be armed or activated. Operation
is automatic, regardless of whether the vehicle is
locked or unlocked.
The system uses a key fob, keyless push button ignition
and a Radio Frequency (RF) receiver to prevent unau-
thorized vehicle operation. Therefore, only key fobs that
are programmed to the vehicle can be used to start and
operate the vehicle. The system cannot reprogram a
key fob obtained from another vehicle.
After placing the ignition in the ON/RUN position, the
Vehicle Security Light will turn on for three seconds for
a bulb check. If the light remains on after the bulb
check, it indicates that there is a problem with the elec-
tronics. In addition, if the light begins to flash after the
bulb check, it indicates that someone attempted to
start the engine with an invalid key fob. In the event
that a valid key fob is used to start the engine but there
is an issue with the vehicle electronics, the engine will
start and shut off after two seconds.
If the Vehicle Security Light turns on during normal
vehicle operation (vehicle running for longer than
10 seconds), it indicates that there is a fault in the elec-
tronics. Should this occur, have the vehicle serviced as
soon as possible by an authorized dealer.
CAUTION!
The Sentry Key Immobilizer system is not compatible
with some aftermarket Remote Start systems. Use of
these systems may result in vehicle starting problems
and loss of security protection.
All of the key fobs provided with your new vehicle have
been programmed to the vehicle electronics
page 263.
NOTE:
A key fob that has not been programmed is also consid-
ered an invalid key.
IGNITION SWITCH
KEYLESS ENTER 'N GO™ IGNITION
This feature allows the driver to operate the ignition
with the push of a button as long as the key fob is in the
passenger compartment.
The START/STOP ignition button has three operating
modes. The three modes are: OFF, ON/RUN, and START.
START/STOP Ignition Button
The push button ignition can be placed in the following
modes:
OFF
•
The engine is stopped.
•
Some electrical devices (e.g., power locks, etc.) are
still available.
ON/RUN
•
Driving mode.
•
All electrical devices are available (e.g., climate con-
trols, heated seats, etc.).
START
•
The engine will start.
Starting The Engine With A Depleted Key Fob Battery
If the ignition state/mode does not change with the
push of a button, the key fob may have a low or
depleted battery. In this situation, a backup method can
be used to operate the ignition switch:
Place the key fob in the cupholder, and then press the
ignition button.
Advertisement
Table of Contents
