Alfa Romeo Tonale Owner's Handbook Manual page 112

If the RESET is not carried out, in all
above cases, the warning light may
give false indications on one or more
tyres.
To perform a RESET, with the car
stopped, the ignition device in ENGINE
position and the iTPMS Widget
displayed on the instrument panel, press
the ring fig. 118 until band (1) fig. 119 is
completely white. If you release the
ring before the procedure is complete,
RESET will fail.
118
1
119
110
OPERATING CONDITIONS
The system is active for speeds above
15 km/h.
In a few situations such as sporty driving,
particular conditions of the road surface
(e.g. icy, snowy, unsurfaced roads) the
signalling may be delayed or partial in
detecting the contemporary deflation of
more than one tyre.
Under special conditions (e.g. car loaded
asymmetrically on one side, towing a
trailer, damaged or worn tyre, fitting the
space-saver wheel, use of the "Fix&Go"
tyre repair kit, fitting snow chains, fitting
different tyres on the axles) the system
may provide false indications or be
temporarily deactivated.
If the system is temporarily deactivated
the warning light flashes for about
75 seconds and then is continuously on;
at the same time, the display shows the
shape of the car and the symbols "– –"
9650060
will appear next to each tyre.
This warning is displayed also after the
engine has been switched off and then on
again if the correct operating conditions
are not restored.
In the case of abnormal signals, it is
recommended to perform the RESET
procedure. If the indications appear
again after a successful RESET, check
that the tyres used on all four wheels
are the same and that the tyres are not
9650090
damaged. As soon as possible, refit the
standard tyre instead of the space-saver
wheel, remove the snow chains, if
possible, check correct load distribution
and repeat the RESET procedure by
driving on a clean, paved road surface. If
the indications persist, contact an Alfa
Romeo Dealership.
DRIVER ATTENTION ASSIST SYSTEM
(where provided)
This is an auxiliary driving assistance
system that detects when the driver is
tired.
ACTIVATION / DEACTIVATION
The system can be
activated/deactivated using the
"Settings" menu of the Alfa Connect
system (see "Settings" in the"Vehicle
in the "Multimedia" section) or via the
instrument panel (see "Settings" in the
"Display" paragraph in the "Knowing the
instrument panel" section).
SYSTEM INTERVENTION
The system intervenes if the camera
in the middle of the windscreen fig. 112
detects that the driver is tired, based on
variations in car trajectory and getting
too close to the side of the road.
The (red) symbol appears on the
instrument panel screen with a dedicated
message suggesting the driver to stop