Removal Of Pcbs - Daikin J Series Service Manual

Indoor Unit
1.6

Removal of PCBs

Procedure
Step
1. Remove the shield plate.
1 The figure shows the
appearance of the
electrical box.
Unfasten the hooks at
2
the upper 2 positions of
the shield plate.
Unfasten the hook at
3
the side of the shield
plate.
4 Lift up the shield plate
to unfasten the lower
hooks and remove it.
2. Remove the terminal
board.
Remove the screw to
1
remove the terminal
board.
147
Warning Be sure to wait for 10 minutes or more after turning off all power
supplies before disassembling work.
Procedure
Control PCB
Signal receiver PCB
Hook
Terminal board
Preparation
Remove the electrical box
Shield plate
according to the "Removal
of Electrical Box".
INTELLIGENT EYE
sensor PCB
(R8083)
Hook
(R8085)
Shield plate
Hook (side)
Hook (lower)
(R10619)
(R10315)
SiBE041101
Points
Removal Procedure