ET9500 Installation and Configuration Guide
4.3 Setting IP Address for Field Network for BACnet/IP and Modbus TCP/IP
•
Open a PC web browser, enter the default IP address of the ET9500 192.168.1.24 into
the URL field to connect to the ET9500.
•
To set IP Address for Field Network select the "Network Settings" Tab from the toolbar
(Figure 9).
•
Modify the IP address (N1 IP Address field) of the ET9500 Ethernet port.
•
If necessary, change the Netmask (N1 Netmask field).
•
Type in a new Subnet Mask
•
If necessary, change the IP Gateway (Default Gateway field)
•
Type in a new IP Gateway
Note: If the ET9500 is connected to a router, the IP Gateway of the ET9500 should be
set to the IP address of the router that it is connected to.
•
Once new IP Address has been entered, click on the newly highlighted button "Update
Settings" (Figure 19).
•
Reset ET9500
•
Remove Power before Unplugging the Ethernet cable from PC and connecting it to the
network hub or router
•
Record the IP address assigned to the ET9500 for future reference.
4.4 Setting up the Device Instance using the Web Configurator
•
After setting your PC to be on the same subnet as the ET9500 (Section 4.1), open a
web browser on your PC and enter the IP address of the ET9500; the default address
is 192.168.1.24.
Figure 9: Changing IP Adress
— 12 —