Intermec PB21 User Manual page 55

PB22/PB32 Mobile Receipt Printer User's Guide
Chapter 3 — Troubleshooting and Maintaining the PB21/PB31
You have options for upgrading the firmware based on whether your
PB21/PB31 has a Bluetooth radio or an 802.11 b/g radio. Use one of
the following procedures to upgrade your printer firmware. Your
printer should reboot after you finish upgrading the firmware. If it
does not reboot, you will need to cold boot the printer. For help, see
"Resetting the PB21/PB31" on page
To upgrade your printer using PrintSet
1 Download the latest version of PrintSet from the Intermec web
site at www.intermec.com.
2 Select File > Add Printer to start the Add Printer Wizard which
guides you through the process of adding your printer.
3 Select your printer under My Printers and then go to Printer >
Firmware Wizard.
The Firmware Wizard guides you through the necessary steps to
update your firmware.
To upgrade your printer using a serial connection
1 Make sure you have established a serial communications between
your PC and the PB21/PB31. For help, see
Communications" on page
2 Use Fingerprint, IPL, or ESC/P commands to send the upgrade file
to the printer.
For help with Fingerprint, IPL, ESC/P, or SmartSystems Foundation
commands and information, see either the
Reference Manual, the
Programmer's Reference
online help. You can download these documents from the Intermec
web site at www.intermec.com.
48.
37.
IPL Command Reference
Manual, or SmartSystems Foundation
"Setting Up Serial
Fingerprint Command
Manual, the ESC/P
49