Field Installation; Installation Kits - Intermec EasyCoder F2 Installation Instructions Manual

Field Installation

Installation Kits

Fitting the Interface
Board
Generally, the illustrations show an
EasyCoder F4 printer. However, the
same principles applies to EasyCoder
F2 printers.
RFID 13.56 MHz Interface Board for EasyCoder F2 and F4 Printers – Installation Instructions
The RFID 13.56 MHz Interface Kit comes in two versions, one
for EasyCoder F2 and another for EasyCoder F4. Each kits
contains:
• One interface board fi tted for RS-232 on "uart2:".
• One fl at cable.
• One antenna (different sizes for EasyCoder F2 and F4.)
• One cable strap
• Two self-adhesive cable straps
• This Installation Instruction booklet.
Circuits for RS-422 non-isolated, RS-422 isolated, and RS-485
can be bought separately from Intermec.
The only tools required are a #T10 Torx screwdriver and a long
#T20 Torx screwdriver. Field installation should only be per-
formed by a skilled service technician.
• Open the electronics compartment by removing the front/
left-hand cover, which is held by three #T20 Torx screws
from the media compartment side of the center section.
Switch off the power and disconnect the power cord. The
electronics compartment contains high voltage compo-
nents and wires. Do not open the electronics compart-
ment before the printer is safely disconnected from any AC
supply.
#T20 Torx screws (3 places)
Chapter 2
Warning!
5