Introduction; Printer Firmware; Installation Kit - Intermec EasyCoder PF2i Install Manual

Preface

Introduction

This Installation Instructions booklet describes how to install an
EasyLAN Ethernet interface in an EasyCoder PF2i, PF4i, PF4i Com-
pact Industrial, or PM4i printer and how to connect it to a LAN, WAN,
Intranet, or Internet network via an RJ-45 network cable.
The installation instructions describes how to physically install the inter-
face board in a printer and how to set up the IP address, netmask, default
router, and name server. The instructions end when you have the print-
er's home page up and running. From there, please refer to the Intermec
EasyLAN User's Guide on the attached CD-ROM.
This interface kit must only be physically installed by an
authorized service technician. Intermec assumes no respon-
sibility for personal injury or damage to the equipment if
the installation in performed by an unauthorized person.

Printer Firmware

The printer must either be fi tted with Intermec Fingerprint v8.00 (or
later) or IPL v2.00 (or later). In Intermec Fingerprint, the Ethernet port
is addressed as device "net1:" (communication channel #5).

Installation Kit

The EasyLAN Interface Kit contains:
• One EasyLAN interface board
• One light guide
• One hexagonal threaded spacer
• One network extension cable
• One cable tie
• One serial number label
• One CD-ROM with software and manuals
• One Installation Instruction booklet
The only tool required for the installation is a #T20 Torx screwdriver and
a small wrench.
iv Intermec EasyLAN Interface Kit Installation Instructions