Fitting the Antenna,
cont.
Grounding Spring
Lower Media Guide
(inner side)
RFID 13.56 MHz Interface Board for EasyCoder F2 and F4 Printers – Installation Instructions
• EasyCoder F4 only: From the electronics compartment,
disengage the snap-lock that holds the cable guard and pull
it out along the shaft.
• Pull out the standard edge guide or the two quick-load
guides.
• Disconnect the LSS cable from connector P53 on the front
edge of the CPU board (marked "LSS.")
• Remove the three #T20 Torx screws that hold the media
guide assembly and pull it out until the connector of the
LSS cable reaches the center section. Be careful not to lose
the grounding spring at the front tip of the assembly.
Media Guide assy.
• At the inside of the front of the lower media guide, there are
two rails for holding the antenna board. Insert the antenna
board with the component side facing down. Gently bend
the antenna cable in a straight angle rearwards, taking care
not to break the soldering.
Snap-lock
#T20 Torx screws (x3)
Antenna Cable
Chapter 2 Field Installation
Cable Guard
(EasyCoder F4 only)
Antenna Board
Rails
9