Printing Recommenda- Tions - Intermec EasyCoder F2 Installation Instructions Manual

Rfid 13.56 mhz interface board
Hide thumbs Also See for EasyCoder F2:
Table of Contents

Advertisement

Chapter 1 Description
Application of Use
Approvals
Interfaces
Printing Recommenda-
tions
2
RFID 13.56 MHz Interface Board for EasyCoder F2 and F4 Printers – Installation Instructions
The RFID 13.56 MHz Interface Board is an optional device for
EasyCoder F2 or EasyCoder F4, that provides these printers with
two extra interfaces, "uart2:" and "uart3:". The printer must be
fi tted with the Intermec Fingerprint v7.xx fi rmware.
The RFID 13.56 MHz Interface Board is either factory-installed in
the printer, or delivered as fi eld-installable kits, one for EasyCoder
F2 and another for EasyCoder F4 (see Chapter 2).
Please refer to Internet
plete and updated list of the countries, in which the RFID 13.56
MHz Interface Board is approved for use. There you can also fi nd
Declarations of Conformity (CE) in all the offi cal languages of the
European Union.
The "uart2:" interface can be fi tted with straps and circuits for one
of the following alternatives:
• RS-232
• RS-422 non isolated
• RS-422 isolated
• RS-485
Refer to Chapter 3 for instructions how to confi gure the interface
board.
The "uart3:" interface connects to a piggyback-fi tted RFID encod-
erthat provides the printer with the capability to write information
to an RFID 13.56 MHz tag in special media during printing. This
requires special application software, that can be found on Internet
(http://printer-rfi
d.intermec.com).
The RFID chip and antenna are usually glued to the back of the
media between the label and the liner. Even if the chip and antenna
are very thin, there will be a small bump at the surface of the
media, which may affect the printout quality, especially in connec-
tion with thermal transfer printing. To get the best printout quality,
consider the following recommendations:
• Increase the printhead pressure by turning the adjustment screw
2–4 turns clockwise (see the printer's User's Guide).
• Avoid placing important information, like bar codes, on top or
in the immidate vicinity of the chip and antenna edges.
• In case of thermal transfer printing, use soft wax-based ribbons
(GP, Standard, or Basewax).
(http://printer-rfi d.intermec.com)
for a com-

Advertisement

Table of Contents
loading

This manual is also suitable for:

Easycoder f4

Table of Contents