Intermec EasyCoder 3400e User Manual page 31

C d
Media
Media
backing
Edge
guide
EasyCoder 3400e Bar Code Label Printer User's Manual
39
Helvetica Condensed Helvetica
If you are replacing the empty media roll with a new roll of the same
width, you do not need to adjust the edge guide or the supply roll
retainer.
3 Place the media roll on the supply roll post and position it firmly against
the printer.
If you are using a narrow roll of media, less than 7.62 centimeters
(3 inches), insert the media support between the roll of media and the
supply roll retainer before securing it.
Head lift
lever
Lower
media guide
4 Slide the supply roll retainer up to the edge of the media roll and turn
the supply roll retainer clockwise to secure.
5 Pull down on the lower media guide to allow easy access to the media
path. Make sure that the edge guide slides all the way to the outer edge
of the lower media guide.
6 Insert the label stock through the printer mechanism as shown. Make
sure the label passes between the upper and lower media guides. The
front edge of the media should pass over the tear bar and out the front
of the printer.
7 Release the lower media guide and adjust the edge guide to position the
media firmly against the inside wall of the printer.
If you are using thermal transfer media, refer to "Loading Thermal
Transfer Ribbon" on page 22 before you finish performing this
procedure.
8 Lower the printhead by rotating the head lift lever counterclockwise
until it locks.
Chapter 2 — Operating the Printer
Upper
media guide
Media roll
Supply roll
post
Supply roll
retainer
Media
support
3XXXU.026
19