Leg Attachment - Blodgett BX-14G Installation Operation & Maintenance

Installation

Leg Attachment

LEG OPTIONS
Legs are available in 4" (101mm), 6" (152mm) or 25"
(635mm) lengths or low profile casters.
• The 4" (101mm) legs may be used when mounting
on a counter.
• The 6" (152.4mm) legs are used on the lower sec-
tion of a double stacked appliance.
• The 25" (635mm) legs are used for a single appli-
ance located on the floor.
NOTE: For safety reasons, casters must not be used
with the 25" (635mm) legs.
25" (635mm) Adjustable Leg
6" (152,4mm) Adjustable Leg
4" (101mm) Leg
Figure 1
Low Profile Casters
ATTACHMENT
1. Align the threaded stud on one of the front legs to the
bolt hole located
appliance. Turn the leg clockwise and tighten to the
nearest full turn.
2. Align the leg plate holes with the bolt holes. Secure
with the two 1/2" bolts provided.
3. Repeat the above steps with the other front leg. If low
profile casters are used, install them with the locking
casters in the front of the oven. The rear casters do
not lock. Ensure that the locks are set on the front
casters.
4. Tip the oven up on the newly installed front legs. If
casters are used, check that the locks are set on
the front casters. Repeat the above steps for the
rear legs.
5. Level the oven by screwing the adjustable feet in or
out as necessary.
6
in the bottom corner of the
Figure 2