Symphonic CSHP80G Service Manual page 21

4. The progression of the Overwriting
process
1. Select the Flash Write tab (See Fig. i), and press
the "File Open" button.
Flash Open button Flash Open button
Flash Write button Flash Write button
Fig. j
2. When the "File Open" button is pressed, a file
selection screen (as shown below) will appear.
Select the "BIN file" to use for overwriting.
Fig. k
3. After the file selection is complete, press the
"Flash Write" button. File compression and
CHECKSUM will be carried out. The "START"
message will appear. Press the "OK" button to
begin the data transfer.
4. On completion of the data transfer, the end of data
transfer message "END" will be displayed and the
G6 Serial Firm Up Software can be safely closed.
The data transfer will take approximately 7
minutes.
5. After completion of the data transfer, the DVR with
DVD Player will begin the erase and over writing
process. This process will take approximately 2.5
minutes.
6. When the progress bar of the DVR with DVD
Player turns fully yellow and "STATUS:OK" is
displayed, the overwriting process is complete and
the power can be turned off.
* When the G6 Serial Firm Up Software is run, the
following may occur but should not be considered a
problem:
1. When a file is selected, the dialog does not
reappear on the screen.
2. The data transfer progress display stops.
1-8-3
Fig. l
E41A1FW