Symphonic CSHP80G Service Manual page 13

Reference Notes
1. Locking Tabs (L-1) and (L-2) are fragile. Be careful
not to break them.
1-1. Release four Locking Tabs (L-1).
1-2. Release three Locking Tabs (L-2) and
remove the Front Assembly.
2. Whenever you have replaced the HDD unit,
initialize the HDD unit. To initialize the HDD unit,
perform the following.
2-1. To put the DVR with DVD Player into the HDD
mode, press the [DVR] button on the remote
control unit.
2-2. To put the DVR with DVD Player into the self-
check mode, after pressing [ANGLE] button,
press the [3], [6], and [9] buttons on the
remote control in that order within three
seconds.
2-3. Press [ENTER] button. The DVR with DVD
Player is initialized and the power is turned
off automatically after two seconds.
3. CAUTION: Electrostatic breakdown of the laser
diode in the optical system block may occur as a
potential difference caused by electrostatic charge
accumulated on cloth, human body etc., during
unpacking or repair work.
To avoid damage of pickup follow next procedures.
3-1. Short the three short lands of FPC cable with
solder before removing the FFC cable
(CN201) from it. If you disconnect the FFC
cable (CN201), the laser diode of pickup will
be destroyed. (Fig. D5)
3-2. Disconnect Connectors (CN301). Remove
two Screws (S-6) with the Earth Plate and
remove the DVD Main CBA Unit. (Fig. D5)
4. CAUTION: When reassembling, confirm the FFC
cable (CN201) is connected completely. Then
remove the solder from the three short lands of
FPC cable. (Fig. D5)
(S-1)
[1] Top Cover
(L-1)
(L-2)
1-6-2
(S-1)
(S-1)
Fig. D1
(L-1)
[2] Front
Assembly
(L-1)
Fig. D2
E41A1DC