Table of Contents
Advertisement
56.
Bowl Check No Valid Fault
While carrying out a bowl check, the machine has not been able to determine a valid bowl status and so
the Display flags this fault. This fault differs from fault code 40 in that a valid bowl status could not be
determined.
Primary Source:
Action:
Secondary Source:
Action:
Tertiary Source:
Action:
57.
Brown Out During Display EEPROM Write Fault
The Display has requested the Motor Control Module to perform an EEPROM write. Prior to writing, the
Motor Control Module has tested the 15 Volt supply and found that it is below the safety level for writing
EEPROM and has reported this to the Display. This may be due to transients at the time of writing or
due to a faulty Motor Control Module.
Primary Source:
Action:
58.
Pressure Transducer at Maximum Adjustment
When the pause or delay start is pressed to start the SmartDrive
memory and found the count greater than expected.
Primary Source:
Action:
60.
Motor Control Memory Check Fault
On power up, the Motor Control Module has checked its memory against a known reference and found
differences.
Primary Source:
Action:
68.
Pressure Transducer Error – Count Too High
The pressure transducer has measured a water level far above what the machine should physically be
able to measure. This suggests that the pressure sensor has been disconnected from the motor
controller, damaged or not actually placed on the PCB.
Primary Source:
Action:
103.
Slave Display Comms Time out
104.
See Fault Code 106
Loading.
Remove items until the remaining ones can move freely, or rearrange the load
so that the clothes are evenly distributed around the bowl, or select a higher
water level. If the load was to one side of the bowl or too heavy, it can be
possible for the agitator to bind in one direction when trying to sense bowl
float.
Mechanical.
1. Check the machine is not siphoning.
2. Check that there are no clothes or other foreign objects preventing the
clutch from re-engaging, and that there aren't any defects with the clutch
mechanism.
3. Check that the pressure tube has not come off and that it is not kinked.
Motor Control Module.
Replace the Motor Control Module.
Motor Control Module.
Replace Motor Control Module.
Motor Control Module.
Replace Motor Control Module
Motor Control Module.
Replace Motor Control Module.
Motor Control Module.
Replace Motor Control Module.
26
, the Display Module has checked the
Advertisement
Table of Contents
