Fisher & Paykel 685 Service Manual page 18

type of fault. After this, if the machine still cannot restart, the fault code
is displayed and the machine will beep continuously. The number of
retries will depend on the fault that it has detected, however the
maximum number or retries for any one fault is 32 times.
NOTE - This feature is designed as a service aid only and should be left
ON in the customer's home. To return to normal operation, and to reset
the RESTART feature to the factory setting, switch the machine off at the
wall or disconnect from the mains supply.
To identify that the RESTART feature has been activated, refer to the Restart
/ Recycle table.
Recycle Feature CleanSmart
At the end of servicing, the machine may require an extended test where the
machine can be left to complete a number of wash cycles. By turning on the
RECYCLE feature, the machine will continuously repeat the wash cycle until
the RECYCLE feature is turned off.
This is indicated in diagnostics mode by selecting the "Sheets"
and ensuring that the Cold Wash Temp LED is off.
To toggle this feature touch the WASH TEMP button this will turn the Cold
Wash Temp LED on or off.
NOTE - This feature is designed as a service aid only and should be
OFF, in the customer's home. To return to normal operation, and to
return the recycle feature to the factory setting, switch the machine off
at the wall or disconnect from the mains supply.
To identify that the RECYCLE feature has been activated, refer to the Restart
/ Recycle table.
Restart Feature WashSmart
The 685 WashSmart™ leaves the factory with the RESTART set to ON,
which is indicated in diagnostic mode by selecting the "Easy Iron"
and ensuring that the No Spin LED, is on.
To deactivate the RESTART feature, touch the "Spin Speed" button which
will turn the No spin LED off.
When servicing the machine, it is more convenient to deactivate the
RESTART feature. This will allow any fault in the system to show up
immediately it occurs.
With the RESTART feature on: (Factory Default setting)
18
cycle
cycle