Washsmart 685; Size Setting; Installation Test - Fisher & Paykel 685 Service Manual

WASHSMART 685

Size setting

When a motor control module is replaced the machine when powered on will
display fault code 9 (required to be size set).
To select Machine Size
6 8 5
With the console Off Press & Hold Key Lock and Spin for 3 Sec. Size Setting Mode
To set the size:
Turn the mains on at the supply and off at the console.
Touch and hold the KEYLOCK and the Spin buttons for 3 seconds until the
LED display shows the current setting of "- - -"or "685".
To select the size touch the More Button until "685" is displayed in the LED screen.
To save the setting power off the console with the Power button, your selection is
automatically saved.

Installation Test

Correct installation of the 685 washer is very important to the performance of
the machine especially the dynamics of the spin cycle. To aid with the
installation an install procedure P/No 421700 is attached on the top of the lid
of each machine, as part of procedure there is an installation test routine that
checks the water inlet hot & cold, drain and low speed spin of the machine.
The test routine will take approximately 3 to 10 minutes depending on the
supply water pressure.
With the console On Press & Hold Key Lock and Options for 3 Sec. Installation Mode
8