Specifications; Replacement Parts - Schumacher SL1338 Owner's Manual

PROBLEM
The jump starter will not
recharge.
The last LED flashes, then
turns off.
When cable is correctly
connected to both battery
and jump starter: Green LED
blinking; Red LED off; no beep.
Smart Cable LED and Alarm Behavior
BEHAVIOR
Green Ready LED blinking;
Red Fault and Clamp Reverse
LEDs off; no beep.
Green Ready LED solid; Red
Fault and Clamp Reverse LEDs
off; no beep.
Red Fault and Clamp Reverse
LEDs solid, Green Ready LED
off; rapid beeping.
No LED illuminated; no beep.
Red Fault LED solid, Green
Ready and Red Reverse
Clamp LEDs off; rapid beeping.
Red Fault and Green Ready
LEDs solid; Red Clamp
Reverse LED off; beeps once
per second.
NOTE: When the condition is corrected, the smart cable will automatically reset.

11. SPECIFICATIONS

Internal battery type .......................................... Lithium ion polymer
Capacity ............................................................................ 26.64 Wh
USB output ....................................................................5V DC, 2.4A
Jump start ................................................600A peak/300A cranking
Charging Temperature.............................. 32 ° to 113 ° F (0 ° to 45 ° C)

12. REPLACEMENT PARTS

Battery clamps/smart cable ............................................ 94500932Z
Micro USB-USB charging cable ................................. 3899003781Z
REASON/SOLUTION
Make sure the power source is live.
Over-discharge. Recharge the internal
battery.
"Fake" high battery voltage is detected,
but reverse charging protection did not
activate. User can turn key to jump start
the vehicle.
Cable is connected to jump starter only.
Cable is connected correctly to both
battery and jump starter.
Reverse polarity protection
Battery exhausted or poor connection
Short circuit protection
Temperature protection
• 8 •
REASON