Double Pulse Door Unlock; Auto Rearm; Entry Delay For Passive Arming; Trunk Bypass - Clarion UNGO MS5500 Install Manual

2 chirps = Logic Sensor II
3 chirps = Optional sensor
4 chirps = hood/trunk
When Audible Tamper Alert report is turned off, the siren will emit a long chirp on disarming
to indicate the system was triggered, but the zone indication will be from the status LED
only.
5. Door Unlock Pulse - Single/Double. Selects between a single pulse or a double pulse
door unlock output.
On many late model Nissan vehicles, as well as some European makes, the factory door
locking system requires two pulses on the proper wire to unlock the vehicle's doors. By
programming the system for double pulse door unlocking, these systems can be interfaced
directly without the use of relays or any additional circuitry.
6. Auto Rearm. When selected, the system will automatically rearm if no other activity is
detected within one minute of Remote Disarming.
One minute after Remote Disarming, the system will alert you with a 10 second series of
chirps, then arm. (If the Passive Door Locking feature is selected during the installation, the
system will also relock the doors.)
Any of the following will cancel Automatic System Rearming:
• Turn on the ignition.
• Open the Trunk or Hood.
• Activate Auxiliary Function 1 or 2.
Automatic System Rearming is independent of Passive Arming and only takes place if the
system was Armed (actively or passively) for at least 20 seconds and then Disarmed by the
Remote Transmitter.
7. Entry Delay for Passive Arming. When selected, the door input trigger will be delayed for
10 seconds, allowing access to the emergency override switch. During the delay cycle, a
series of warning chirps wil be heard until the system fully triggers. Only delays when the
system is armed passively.
8. Trunk Bypass. When selected, pressing an auxiliary function to open the trunk while the
system is armed will allow the trunk to be accessed without triggering the alarm. The Logic
Sensor, optional sensors, and trunk pin switch will be disabled until the trunk is closed.

9. Illuminated Exit.

when the ignition is turned off.
10. Auxiliary Function 2 - Momentary / Latched / Timed Operation. (resets with arm and
disarm) Selects between Momentary, Latched, or Timed output for Aux. 2.
When Momentary operation is selected, the system will provide an output for as long as
the Transmitter button is held.
When Latched operation is selected, the system will provide an output that turns on when
the transmitter button is pressed and turns off when the transmitter button is pressed again.
When Timed operation is selected, the system will provide an output that turns on for 30
seconds each time the transmitter button is pressed. If the button is pressed again during
Page 18 - MS5500 Installation Manual
When selected, the vehicle's dome light will illuminate for 20 seconds