Advertisement
1
SAFETY AND WARNINGS
Before you install the appliance, please make sure
that
the local distribution conditions (nature of gas and
pressure) and the adjustment of the appliance are
compatible. For adjustment conditions for this
appliance see 'Gas rate summary'
a suitable disconnection switch is incorporated in
the permanent wiring, mounted and positioned to
comply with the local wiring rules and regulations. A
means of disconnection with at least a 3 mm air gap
contact separation in all poles must be incorporated
into the fixed wiring in accordance with the
wiring rules, unless the local wiring rules allow for
alternative means
the appliance is connected to a 220V - 240V 50Hz
(10 A) power supply only and earthed via the power
supply cable.
there is a power outlet within reach of the appliance.
This must be accessible after installation. The power
supply cable should not touch any metal parts
if the power supply cable is damaged, it is replaced
only by the special cable: Part no. 534906 TRMNL
BLOCK-FLEX ASSY HITEMP GOG UK, obtainable from
authorised Fisher & Paykel Service Agents. Please
see your 'Service and Warranty' booklet for contact
details
the supply connection point (gas shut-off valve) is
accessible after installation.
the benchtop is made of a heat resistant material
the installation complies with all the current
requirements of National and Local Authority Gas,
Electric and other relevant Codes and Regulations.
When you install the appliance
We do not recommend you flush mount or seal
this appliance into the bench with silicone or glue.
Doing so will make future servicing difficult. Fisher &
Paykel will not be liable for any costs associated with
removing or replacing a sealed-in appliance, nor for
repairing any damage that may be incurred by doing
this.
If installed with an approved flexible hose, the
hose should not come in contact with the bottom
of the appliance or any sharp edges. Flexible hose
assemblies should comply with local regulations.
Seal exposed bare edges of the cutout with an oil-
based paint or moisture-proof polyurethane to
prevent possible moisture creeping between the
cooktop trim and the benchtop.
Take extreme care not to chip, crack, or break the
top glass surfaces during installation. A heavy metal
tool or part accidentally dropped on the glass could
damage it.
If, after following the instructions given, correct
performance cannot be achieved, please contact
Customer Care, or contact us through our local
website listed at the end of this document.
3
Advertisement
