Advertisement
AFFIX DUPLICATE DATA LABEL SOMEWHERE
15
ACCESSIBLE & PLUG COOKTOP IN
Duplicate data
label
TEST OPERATION
17
To check that the ignition system operates correctly, light each burner by itself, then all burners in
combination.
Check for a well‐defined blue flame without any yellow tipping.
If any abnormality is evident, check that the components of the burner assembly are located properly
If proper operation cannot be obtained, contact Customer Care.
The cooktop must not be used by the customer until proper operation has been achieved.
lifting o
yellow tip
good ame
To enable the gas supply to be readily shut o by the customer, make sure the conne
is tted with an isolating valve close to the cooktop.
16
FIT PAN SUPPORTS
If connecting the gas with a exible hose:
Ensure the hose is long enough to allow for removal of cooktop for servicing.
Make sure the connector is located as shown in step 3 CLEARANCE DIMENSIONS.
The hose assembly must be AS/NZS 1869 Class B or D certi ed, with an Rp ½" (ISO 7
Ensure the pan supports are
The hose assembly must be as short as practicable and comply with relevant AS 560
located securely and in the
correct orientation
The hose must not be kinked, subjected to abrasion or permanently deformed.
(refer to User guide)
The hose must not be near or in contact with any hot surfaces
(e.g. base of metal hotlplate, ue, or chassis of underbench oven etc.)
GAS
GAS
ON
ON
12
check all
Advertisement
