Fisher & Paykel WH2424P1 Troubleshooting Manual page 3

suds Too much detergent used.
Inlet hose or drain
hose leaking.
Lots of suds.
Small
puddle of Detergent
water from dispenser blocked.
under
the
Detergent
machine
dispenser drawer not
fully closed.
Damage to door seal.
Wash time is
Cycle time
approximate.
longer than
usual/
Low water pressure
Inaccurate
or flow rate.
time
reading/
Out of balance
Adjustment
or oversudsing.
of
time
Washing a large load.
remaining
during
Selecting various
cycle
options.
Detergent drawer
not properly closed or
was
opened part way
Detergent
through the cycle.
or
fabric
Dirty or blocked
softener
detergent dispenser.
remaining
in
detergent
Liquid sitting at the
dispenser
'Max' level at the end
at the
of the
end of the
cycle indicates a
cycle
blockage.
Dispenser over
loaded with detergent.
https://producthelp.fisherpaykel.com/us/Wash/Front_Loaders/WashSmart/WH2424P1/User_Guide_WH2424P1/16_troublesh...
Ensure the correct dose of detergent is used for the load size and
soil level (refer to page 28).
Check inlet hose(s) and the drain hose are correctly attached and
not damaged.
Suds may have leaked and then dissolved.
Clean detergent dispenser drawer (refer to page 37).
Close detergent dispenser drawer fully and ensure it remains closed during
the cycle.
Check seal inside door for damage. If it sustains any damage it will need
to be replaced.
Wash time may be influenced by a number of factors (refer to page 22).
Ensure that inlet hose filters are not blocked.
Recovery from out of balance or oversudsing will extend cycle time (refer to
pages 40 – 41).
Be aware that it will take longer for the machine to fill.
Be aware that some options will
extend cycle time.
Ensure the detergent dispenser drawer is fully closed at the start of the
cycle and remains closed
throughout the cycle.
Clean the detergent dispenser (refer to page 37).
Clean the fabric softener dispenser (refer to page 37).
Clean out remaining detergent and refer to page 28 for dosing information.
Updated: Tue, 16 Nov 2021 12:12:43 GMT
Powered by
3