Fisher & Paykel WD8060P1 Troubleshooting Manual page 7

Problem Possible Causes
Incorrect wash
temperature
selected in relation
to the type of soil.
Cycle selected not
appropriate.
Washing
very wet at Incorrect spin speed
the end of for load selected.
the cycle
An out of balance
load has occurred.
Solving Dryer Problems
Problem Possible Causes
Dryer set to 'Air
Dry' cycle.
Dryer does
not heat
The dryer has
progressed to cool.
Drying cycle
selected not
appropriate for the
load.
'Dryness Level'
Dryer is
selected not
taking too
appropriate for the
long/results
load.
were not
satisfactory
Dryer overloaded
for the cycle.
Environmental
conditions may be
https://producthelp.fisherpaykel.com/eu/Wash/Front_Loaders/Washer_Dryer_Combo/WD8060P1/User_Guide_WD8060P1/16...
Select a wash temperature suitable for the type of soil, eg warm for greasy
soils, cold for muddy soils. Increasing the wash temperature generally
improves soil removal and overall wash performance.
Particularly short or delicate cycles have shorter spins which can result in
wetter washing at the end of the cycle.
Select a faster spin speed.
The washer dryer compensates for the out of balance by using a lower spin
speed, to reduce noise and potential damage to itself.
Check what cycle the dryer is set to, change to the preferred cycle (refer to
'Wash & Dry Cycles').
The dryer will progress and display
(refer to 'Wash & Dry Cycle Options').
Select an appropriate cycle for the load (refer to 'Sorting & Loading').
Select a higher dryness level (refer to 'Sorting & Loading').
Each cycle has a maximum load size (refer to 'Wash & Dry Cycles').
Try dividing the load in two and dry half at a time.
In hot, humid conditions the dryer will take longer to dry a load and be less
efficient.
What To Do
What To Do
Updated: Wed, 17 Nov 2021 19:03:07 GMT
Powered by
7