Fisher & Paykel WD8060P1 Troubleshooting Manual page 3

Problem
Load is out of
balance.
Inlet hose or
drain hose
leaking.
Lots of suds.
Detergent
Small puddle of
dispenser
water from
blocked.
under the
machine
Detergent
dispenser
drawer not fully
closed.
Damage to
door seal.
The 'Wrinkle
Washer dryer
Free' option
keeps stopping
has been
and starting
selected.
Solving General Operating Problems
Problem
Not spinning properly
https://producthelp.fisherpaykel.com/eu/Wash/Front_Loaders/Washer_Dryer_Combo/WD8060P1/User_Guide_WD8060P1/16...
Possible
Causes
Wash an average sized load rather than a smaller load or a single item.
Washing or drying one item at a time is not recommended as it is difficult for
the washer dryer to balance a single item during spin.
Check inlet hose and the drain hose are correctly attached and not damaged.
Suds may have leaked and then dissolved.
Clean detergent dispenser drawer (refer to 'Caring for your Washer Dryer').
Close detergent dispenser drawer fully and ensure it remains closed during
the cycle.
Check seal inside door for damage. If it sustains any damage it will need to
be replaced.
Refer to 'Wash and Dry Cycle Options' for more information.
Possible Causes
Load has gone out of balance.
Machine is not level.
Suds build up.
What To Do
What To Do
Open door and redistribute load, then restart
the washer dryer.
Ensure machine is correctly levelled (refer to
'Installation Instructions - Levelling the
Machine').
Check the amount of detergent used, reduce
if necessary (refer to 'Detergent & Fabric
Softener').
Updated: Wed, 17 Nov 2021 19:03:07 GMT
Powered by
3