Fisher & Paykel WD8060P1 Troubleshooting Manual page 5

Problem
Washer dryer is not draining
Filling continuously
Poor rinsing
Cycle time longer than usual/
Inaccurate time reading/
Adjustment of time remaining
during cycle
Dye transfer
https://producthelp.fisherpaykel.com/eu/Wash/Front_Loaders/Washer_Dryer_Combo/WD8060P1/User_Guide_WD8060P1/16...
Possible Causes
Drain hose sitting in
water.
Drain hose blocked.
Pump filter blocked.
Drain hose higher than
1200mm above floor
level.
Drain hose not
connected to
standpipe or tub.
Machine siphoning.
Incorrect detergent
used.
Too much detergent
used.
The wash and drying
time is approximate.
Low water pressure or
flow rate.
Out of balance or
oversudsing.
Washing a large load.
Selecting various
options.
Coloured items not
washed separately
from white/light
coloured items.
What To Do
Clear the drain.
Clear the drain hose.
Clear the pump filter (refer to 'Caring for your
Washer Dryer').
Lower the level of the drain hose (refer to 'Installation
Instructions - Draining').
Connect drain hose correctly (refer to 'Installation
Instructions - Draining').
Ensure standpipe or tub is at least 800mm from the
floor level.
Use low sudsing, front loader detergent only (refer to
'Detergent & Fabric Softener').
Ensure the correct dose of detergent is used for the
load size and soil level (refer to 'Detergent & Fabric
Softener').
Wash and drying time may be influenced by a
number of factors (refer to 'Washer Dryer Controls').
Ensure that the inlet hose filter is not blocked.
Recovery from out of balance or oversudsing will
extend cycle time (refer to 'Before you call for
Service').
Be aware that it will take longer for the machine to
fill.
Be aware that some options will extend cycle time.
Remember to separate whites and colours.
Updated: Wed, 17 Nov 2021 19:03:07 GMT
Powered by
5