Fisher & Paykel WD8060P1 Troubleshooting Manual

Troubleshooting
The following is a list of problems you may encounter when using this appliance and some suggestions that may help to
correct the problem. If you still have problems, please contact your Fisher & Paykel trained and supported service
technician.
Solving General Operating Problems
Problem Possible Causes
Electrical cord not
plugged into a power
socket.
Power not switched
on at the wall.
Washer
dryer not
Household power
turning
supply not working.
on
'Keylock'
may be activated.
Washer dryer door not
Touching
closed properly. Open
and reclose door.
The washer dryer has
does not
detected a fault.
start filling
or drying
Cold tap turned off.
https://producthelp.fisherpaykel.com/eu/Wash/Front_Loaders/Washer_Dryer_Combo/WD8060P1/User_Guide_WD8060P1/16...
Plug cord into a power socket.
Switch the power on at the wall. Then touch 'POWER'.
Try plugging another electrical appliance into the same socket. Turn off the
power at the power point. Unplug the washer dryer from the power socket.
Wait 60 seconds, plug it back in, turn it on and try again.
Touch and hold the 'POWER' button for 2 seconds. Refer to 'Caring for your
Washer Dryer'.
Open and reclose door.
Check if a code is being displayed on the panel. (Refer to 'Before you Call for
Service' and 'Fault Codes').
Check that the cold tap is turned on.
What To Do
Updated: Wed, 17 Nov 2021 19:03:07 GMT
Powered by
1