Printer Setup Mode; Self-Test Mode - Citizen CLP-2001 User Manual

2.4

Printer Setup Mode

The printer enters the printer setup mode when both Pause and Feed keys
are pressed simultaneously. The control key functions at this time are
described below.
Settings of the printer setup mode are stored in nonvolatile memory, so once
they are set, they are remained even when the power is turned off.
[Functions]
Set the print mode selection, peeling sensor ON/OFF, auto-cutter
ON/OFF etc.
Pause key:
Feed key:
Stop key:
Item
↓
Direct-thermal/thermal
transfer printing
↓
Peeling sensor
↓
Auto-cutter
↓
Tearing
↓
Sensor selection
2.5

Self-Test Mode

The printer enters the self-test mode when the Feed key is pressed and held
down while turning the printer on.
[Functions]
The printer performs the test print and enters the data dump mode (prints
communication data with ASCII codes). The printer returns to the normal
operating mode when the power is turned off.
If the Feed key is pressed further for five seconds after the printer has
entered the self-test mode, the test print will be performed in the continuous
paper mode, regardless of sensor selection stored in backup memory.
Selects the mode.
Selects the mode item.
Saves settings and returns the printer to normal
operating mode.
LCD indication
Direct TM → Transfer →
Peel OFF → Peel ON →
Cut OFF→ Cut ON →
Tear OFF → Tear ON →
Edge → Reflect → ContinuP →
2-4