Wash Cycle Options - Fisher & Paykel WH1260P1 Installation Manual/User Manual

Once you have selected your wash cycle you may wish to change the default wash options.

Wash cycle options

All wash cycles default to the recommended options for that cycle based on the average
expected load to be washed. You can vary the options (eg
create your desired cycle. Some options are not available on some cycles, for clothes care
reasons, or because the option is not appropriate for the cycle.
To change a wash option or options you have selected after a cycle has started
1
Wash Temp
Your washer offers these wash temperatures:
COLD TAP
Incoming water
from tap
Simply press the
Some temperatures are not available on some cycles as a safeguard for your clothes
(eg
temperatures above 40°C on the DELICATE cycle
The washer will fill with both hot and cold water (if possible) to achieve the selected wash
temperature. If required, ie for cold supply or cold connection only, the washer will heat the
water to the selected temperature.
If you do not wish to heat the water to 20°C using the internal heater, refer to the
'Changing pre-set options' section for detail on how to set
temperature for your cold water wash.
32
WASH CYCLE OPTIONS
CONTROLLED
COLD
20°C
button to increase or decrease the wash temperature.
WASH TEMP
Press
then press
the new setting(s).
WARM / COLD WARM
30°C
).
WASH TEMP, SPIN SPEED
and select your new setting,
again to resume the cycle with
HOT
40°C 60°C
as the default
COLD TAP
) to
EXTRA
HOT
90°C