Copying Memory Contents - Icom IC-RX7 Instruction Manual

7
MEMORY PROGRAMMING

■ Copying memory contents

This function copies a memory channel's contents to another
memory channel. This is useful when searching for signals
around a memory channel frequency and for recalling the
offset frequency, subaudible tone frequency etc.
q Select the desired memory channel to be copied.
➥ Push [SCAN] to start a scan, then push [HOLD V] to
hold the scan.
➥ Rotate [DIAL] to select the channel.
• Push and hold [v] or [w] for 1 sec. to change the category,
or push [v] or [w] to change the group.
w Push and hold [ENT MW] for 1 sec. to enter memory pro-
gramming state.
• 1 short and 1 long beep sound.
e Push [s] once (or rotate [DIAL]) to select "COPY," then
push [ENT MW].
56
r Push [r] or [s] (or rotate [DIAL]) to select the desired
category or "ADDITION," then push [ENT MW].
• When "ADDITION" is selected, new category can be pro-
grammed (see p. 52 for new category programming details).
t Push [r] or [s] (or rotate [DIAL]) to select the desired
group or "ADDITION," then push [ENT MW].
• When "ADDITION" is selected, new group can be programmed
in the category (see p. 53 for new group programming details).