Switching Input Signal - BenQ TW526E User Manual

6. You have successfully assigned a new
password to the projector. Remember to
enter the new password next time the
projector is started.
7. To leave the OSD menu, press MENU/EXIT.
Disabling the password function
To disable password protection, go back to the SYSTEM SETUP: Advanced >
Security Settings > Power on lock menu after opening the OSD menu system.
Select Off by pressing
the current password.
• If the password is correct, the OSD menu returns to the Security Settings
page with 'Off' shown in the row of Power on lock. You will not have to enter
the password next time you turn on the projector.
• If the password is incorrect, the password error message displays lasting for three
seconds, and the message 'INPUT PASSWORD' displays for your retry. You
can press MENU/EXIT to cancel the change or try another password.
Though the password function is disabled, you need to keep the old
password in hand should you ever need to re-activate the password
function by entering the old password.

Switching input signal

The projector can be connected to multiple devices at the same time. However, it can
only display one full screen at a time. When starting up, the projector automatically
searches for the available signals.
Be sure the Quick Auto Search function in the SOURCE menu is On (which is
the default of this projector) if you want the projector to automatically search for the
signals.
You can also manually cycle through the
available input signals.
1. Press SOURCE on the projector or
remote control. A source selection bar
displays.
2. Press
selected and press MODE/ENTER.
Once detected, the selected source
information will display on the screen for
seconds. If there is multiple equipment
connected to the projector, repeat steps 1-2
to search for another signal.
• The brightness level of the projected
image will change accordingly when
you switch between different input signals. Data (graphic) "PC"
presentations using mostly static images are generally brighter than
"Video" using mostly moving images (movies).
/ . The message 'INPUT PASSWORD' displays. Enter
/ until your desired signal is
Operation 33