BenQ TW526E User Manual page 39

If you have purchased a test disc which contains various color test patterns and can be
used to test the color presentation on monitors, TVs, projectors, etc. You can project
any image from the disc on the screen and enter the 3D Color Management menu
to make adjustments.
To adjust the settings:
1. Go to the PICTURE menu and highlight 3D Color Management.
2. Press MODE/ENTER and the 3D Color Management page displays.
3. Highlight Primary Color and press
Yellow, Green, Cyan, Blue, or Magenta.
4. Press to highlight Hue and press
range will include colors consisted of more proportions of its two adjacent
colors.
Please refer to the illustration to the right
for how the colors relate to each other.
For example, if you select Red and set its
range at 0, only pure red in the projected
picture will be selected. Increasing its range
will include red close to yellow and red close
to magenta.
5. Press to highlight Saturation and
adjust its values to your preference by
pressing /
will reflect to the image immediately.
For example, if you select Red and set its
value at 0, only the saturation of pure red will be affected.
Saturation is the amount of that color in a video picture. Lower settings produce
less saturated colors; a setting of "0" removes that color from the image entirely. If
the saturation is too high, that color will be overpowering and unrealistic.
6. Press to highlight Gain and adjust its values to your preference by pressing
/ . The contrast level of the primary color you select will be affected. Every
adjustment made will reflect to the image immediately.
7. Repeat steps 3 to 6 for other color adjustments.
8. Make sure you have made all of the desired adjustments.
9. Press MENU/EXIT to exit and save the settings.
Resetting current or all picture modes
1. Go to the PICTURE menu and highlight Reset Picture Settings.
2. Press MODE/ENTER and press
• Current: returns current picture mode to the factory preset settings.
• All: returns all settings, except User 1/User 2 in the PICTURE menu to the
factory preset settings.
. Every adjustment made
/ to select a color from among Red,
/ to select its range. Increase in the
RED
Magenta
/ to select Current or All.
Yellow
GREEN
Cyan
BLUE
Operation 39