Loading Paper And Specialty Media; Setting The Paper Size And Paper Type; Configuring Universal Paper Settings - Ricoh InfoPrint 1767 User Manual

Loading paper and specialty media

This section explains how to load the 520-, 850-, and 1150-sheet trays, and the multipurpose feeder. It also includes
information about paper orientation, setting the Paper Size and Paper Type, and linking and unlinking trays.

Setting the Paper Size and Paper Type

The Paper Size setting is determined by the position of the paper guides in the tray for all trays except the
multipurpose feeder. The Paper Size setting for the multipurpose feeder must be set manually. The factory default
Paper Type setting is Plain Paper. The Paper Type setting must be set manually for all trays that do not contain plain
paper.
1 Make sure the printer is on and Ready appears.
2
From the control panel, press
3
Press repeatedly until
4
Press repeatedly until
5
Press repeatedly until the correct tray appears, and then press
6
Press repeatedly until
7
Press or repeatedly until the correct Paper Type setting appears, and then press
Submitting Selection appears.

Configuring Universal paper settings

The Universal Paper Size is a user-defined setting that lets you print on paper sizes that are not preset in the printer
menus. Set the Paper Size for the specified tray to Universal when the size you want is not available from the Paper
Size menu. Then, specify all of the following Universal size settings for your paper:
•
Units of measure (inches or millimeters)
•
Portrait Height and Portrait Width
• Feed Direction
Note: The smallest supported Universal size is 100 x 148 mm (3.9 x 5.8 in.); the largest is 305 x 483 mm
(11.7 x 19 in.).
Specify a unit of measurement
1 Make sure the printer is on and Ready appears.
2
From the control panel, press
3
Press repeatedly until
4
Press repeatedly until
.
Paper Menu appears, and then press
Paper Size/Type appears, and then press
appears next to the correct size, and then press
.
Paper Menu appears, and then press
Universal Setup appears, and then press
23
.
.
.
.
.
.
.