Ricoh InfoPrint 1767 User Manual page 81

Menu item
Power Saver
Disabled
2–240
Standby Mode
Disabled
1–240
Alarms
Alarm Control
Toner Alarm
Staple Alarm
Hole Punch Alarm
Timeouts
Screen Timeout
15–300
Timeouts
Print Timeout
Disabled
1–255
Description
Sets the amount of time in minutes the printer waits after a job is printed before it
goes into a reduced power state
Notes:
•
Disabled does not appear unless Energy Conserve is set to Off.
•
The factory default setting depends on the printer model. Print a menu
settings page to view the current setting.
•
Lower settings conserve more energy, but may require longer warm-up times.
•
Select the lowest setting if the printer shares an electrical circuit with room
lighting or you notice lights flickering in the room.
•
Select a high setting if the printer is in constant use. Under most
circumstances, this keeps the printer ready to print with minimum warm-up
time.
Sets the amount of time in minutes the printer waits—in a ready-to-print state,
after a job is printed—before passing into Power Saver mode
Notes:
•
Disabled is the factory default setting.
•
This setting must be less than or equal to the Power Saver mode setting.
Sets an alarm to sound when the printer requires operator intervention
Available selections for each alarm type are:
Off
Single
Continuous
Notes:
•
Single is the factory default setting for Alarm Control. Single sounds three
quick beeps.
•
Off is the factory default setting for Toner Alarm, Staple Alarm, and Hole
Punch Alarm. Off means no alarm will sound.
•
Continuous repeats three beeps every 10 seconds.
• Stapler Alarm and Hole Punch Alarm are available only when the finisher is
installed.
Sets the amount of time in seconds the printer waits before returning the printer
display to a Ready state
Note: 30 seconds is the factory default setting.
Sets the amount of time in seconds the printer waits to receive an end-of-job
message before canceling the remainder of the print job
Notes:
•
90 seconds is the factory default setting.
•
When the timer expires, any partially printed page still in the printer is printed,
and then the printer checks to see if any new print jobs are waiting.
•
Print Timeout is available only when using PCL or PPDS emulation. This
setting has no effect on PostScript emulation print jobs.
81