Fisher & Paykel OR90SCI6 User Manual page 77

Cooktop Cooktop
PROBLEM
Some or all displays
flash or there is a
continuous beep.
Pans do not become hot.
The heat setting display
comes on, but the
not flash when I remove
a pan.
-0- shows in the timer
display when I turn on
the cooktop.
Condensation is forming
on surrounding walls,
cabinetry or your overhead
rangehood.
Some pans make crackling
or clicking noises.
The cooktop makes a low
humming noise when used
on a high heat setting
(especially PowerBoost).
TROUBLESHOOTING
POSSIBLE CAUSES
The control dials have been held in
either A or
The cooktop is in 'Display mode'.
does
This is a normal for induction
cooking.
Energy efficient technology
means that no heat is lost to
surrounding surfaces. This results
in condensation forming on these
cooler surfaces when steam is
produced by cooking.
This may be caused by the
construction of your cookware
(layers of different metals
vibrating differently).
This is caused by the technology
of induction cooking.
position for too long.
WHAT TO DO
Turn the control dial back to OFF
and wait until the error flash has
disappeared before trying to use
the cooktop again.
Contact Customer Care or your
Fisher & Paykel trained and
supported service technician.
This is normal for induction
cooking and does not indicate
a fault.
To minimise condensation:
• Ensure adequate ventilation
when cooking.
• Switch your rangehood on
5 minutes before cooking and
let it run for at least minutes
after cooking.
•
Use your rangehood on a lower
speed setting when boiling.
• Use the cooktop on a lower
heat setting when boiling.
• Use pot lids to stop moisture
from escaping.
• If condensation forms, wipe
down surrounding walls and
cabinetry as needed.
This is normal for induction
cookware and does not indicate
a fault.
This is normal, but the noise
should quieten down or disappear
completely when you decrease the
heat setting.
77