Table of Contents
Advertisement
Attention
Be careful of the following points when using the built-in calibration sensor.
Do not touch the built-in calibration sensor.
It may reduce the measurement accuracy of the built-in calibration sensor, or result in injury
or equipment damage.
Attention
• A high temperature or high humidity environment may affect the measurement accuracy of the built-in
calibration sensor. We suggest storing and using the monitor under the following conditions.
- Temperature 30ºC or less
- Humidity 70 % or less
Avoid storing or using the sensor where it may be exposed to direct sunlight.
• Since the measurement result for the built-in sensor may be affected, ensure that the level of ambient light
that enters the receiver part of the built-in sensor does not change significantly during measuring. Do not
touch the screen while measurement is in progress.
- The use of a monitor hood is recommended.
- While measuring, do not bring your face or any objects close to the monitor, do not look into the sensor.
- Set the monitor in the environment so that external light does not enter the sensor directly.
Note
• This monitor supports a portrait orientation display. When using the screen in a portrait position, you can
change the orientation of the Setting menu (see
• When using the monitor screen in a portrait position, the graphics board supporting portrait display is
required. When placing the monitor in a portrait position, settings of your graphics board need to be
changed. Refer to the User's Manual of the graphics board for details.
"Menu Rotation" (page
29)).
Chapter 1 Introduction
7
Advertisement
Table of Contents
