Imaging Problems (For Both Digital And Analog); Imaging Problems (For Analog Only) - Eizo DuraVision FDX1203-BK User Manual

5-2. Imaging problems (for both digital and analog)

Problem
1. The screen is too bright or too dark.
2. Characters are blurred.
3. Afterimages appear.
4. Green / red / blue / white dots or defective
dots remain on the screen.
5. Interference patterns or pressure marks
remain on the screen.
6. Noise appears on the screen.

5-3. Imaging problems (for analog only)

Problem
1. Display position is incorrect.
2. Vertical bars appear on the screen or a
part of the image is flickering.
3. Whole screen is flickering or blurring.
22
Chapter 5 Troubleshooting
Possible cause and remedy
• Adjust "Brightness" in the Setting menu. (The LCD
monitor backlight has a limited life span. When the screen
becomes dark or begins to flicker, contact your local EIZO
representative.)
• Check whether the PC is configured to meet the resolution
and vertical scan frequency requirements of the monitor
(see "Compatible Resolutions" in the Setup Manual).
• When an image is displayed with a resolution other than
recommended, the characters or lines of the displayed
image may blur. Use "Smoothing" in the Setting menu to
adjust it (see "To modify blurred characters / lines" (page
16)).
• Afterimages are particular to LCD monitors. Avoid
displaying the same image for a long time.
• Use the screen saver or power save function to avoid
displaying the same image for extended periods of time.
• This is due to LCD panel characteristics and is not a
failure.
• Leave the monitor with a white or black screen. The
symptom may disappear.
• When entering the HDCP signals, the normal images may
not be displayed immediately.
Possible cause and remedy
• Use "Position" in the Setting menu to correct the image
position (see "To correct the screen position" (page
• If the problem persists, use the graphics board's utility if
available to change the display position.
• Use "Clock" in the Setting menu to adjust it (see
eliminate vertical bars" (page
• Use "Phase" in the Setting menu to adjust it (see
remove flickering or blurring" (page
15)).
"To
14)).
"To
15)).