Table of Contents
Advertisement
Chapter 5 Troubleshooting
If a problem still remains after applying the suggested remedies, contact your local EIZO representative.
5-1. No picture
Problem
1. No picture
• Power indicator does not light.
• Power indicator is lighting blue.
• Power indicator is lighting orange.
2. The message below appears.
• The message shows that the input signal is
out of the specified frequency range.
Example:
Possible cause and remedy
• Check whether the power cord is connected properly.
• Press
.
• Increase "Brightness" and / or "Gain" in the Setting menu
(see
"To perform advanced adjustments" (page
• Switch the input signal with
• Move the mouse or press any key on the keyboard.
• Check whether the PC is turned on.
• Depending on the PC and graphics board, the input signal
is not detected and the monitor does not recover from
the power saving mode. If the screen is not displayed
even after moving the mouse or pressing any key on the
keyboard, turn the monitor off and on using its power
button. When the screen is displayed, execute the
following procedure. The problem may be improved.
1.
Press
to turn off the monitor.
2.
Hold down
while pressing
monitor.
"x" is displayed on the menu title of "Information" of the
Setting menu (see
"6-2. Displaying Monitor Information"
(page
25)).
3.
Reboot the PC.
To return to the previous setting, perform steps 1 to 3
again.
This message appears when the signal is not input correctly
even when the monitor functions properly.
• Check whether the PC is configured to meet the resolution
and vertical scan frequency requirements of the monitor
(see "Compatible Resolutions" in the Setup Manual).
• Reboot the PC.
• Select an appropriate setting using the graphics board's
utility. Refer to the User's Manual of the graphics board
for details.
9)).
.
to turn on the
Chapter 5 Troubleshooting
21
Advertisement
Table of Contents
