Cisco SFS 7024 Hardware User's Manual page 73

Cisco systems infiniband server switch users guide
Table of Contents

Advertisement

Chapter
Figure 3-23 Device Tab: Software Module Configurator
To change any Log Level settings:
Click the On-Off checkbox to the right of the setting.
Step 1
Click the Submit button to save any changes.
Step 2
The following list describes each of the Log Level configuration parameters.
OL-8794-04
DUMP – Dump: Indicates that a problem has caused the system to produce a system dump file.
In most circumstances, it is recommended that the user retrieve the dump that was produced.
Support engineers may require the information contained in the dump file to diagnose the cause
of the problem.
FATAL – Indicates that a non-recoverable system problem has occurred. The user should reboot
the system or component and verify that the subsystem is fully functional to determine whether
the fault has been corrected. If the problem persists, the user should contact the supplier.
ERROR – Indicates that a serious system error has occurred which might be recoverable. If the
system exhibits any instability, the user should reboot the system or component. If errors persist,
the user should immediately contact the supplier's technical support.
ALARM - Indicates that a serious problem has occurred which degrades capacity or service. If
the error is recoverable, the user should correct the failure. If the alarm/failure persists, the user
should reboot the system at a convenient time. If the problem is still not cleared, the user should
contact the supplier.
WARNING - Indicates that a recoverable problem has occurred. The user does not need to take
action.
PARTIAL - When more information is available, Partial causes additional message-related
details to be displayed.
CONFIGURATION: An informational message indicating changes that a user has made to the
system configuration. The user does not need to take any action.
INFO: Informational messages that occur during a system or component boot. The user does
not need to take any action.
PERIODIC: An informational message containing periodic statistics. The user does not need
to take action.
Cisco SFS 7024 InfiniBand Server Switch Hardware Users Guide
55

Advertisement

Table of Contents
loading

Table of Contents