Cisco SFS 7024 Hardware User's Manual page 46

Figure 2-14 SFS 7024 Chassis Back View
Connect a Category 5 or 6 (Cat 5/6) Ethernet cable to one of the RJ-45 connectors on the SFS 7024.
Step 1
Connect the other end of the Cat 5/6 to the OOB LAN workstation. Refer to
connector(s) to use:
Connect the switch to IB-enabled hosts using 4X-to-4X IB cables.
Step 2
Make sure all cables latch securely into the corresponding port connectors. If the IB cable connector is
Note
not properly oriented to fit onto the port receptacle (i.e., while attempting to insert the cable in the port),
do not twist the connector to achieve the correct orientation. Instead, reach back a few feet on the cable,
and twist the bulk cable to allow the connector to rotate to the proper orientation. Doing this prevents all
of the rotational forces from acting right at the connector terminations.
It is important to provide strain relief for the IB cable connector.
Caution
Cisco SFS 7024 InfiniBand Server Switch Hardware Users Guide
28
RJ-45 for Spine 5
AC power inlet for power
supplies 7 to 9
Leaf 23
Leaf 21
Leaf 19
Leaf 17
Leaf 15
Leaf 13
Leaf 11
Leaf 9
Leaf 7
Leaf 5
Leaf 3
Leaf 1
AC power inlet for power
supplies 1 to 3
RJ-45 for Spine 1
RJ-45 for Spine 6
AC power inlet for power
supplies 10 to 12
Leaf 24
Leaf 22
Leaf 20
Leaf 18
Leaf 16
Leaf 14
Leaf 12
Leaf 10
Leaf 8
Leaf 6
Leaf 4
Leaf 2
AC power inlet for power
supplies 4 to 6
RJ-45 for Spine 2
Figure 2-14
Chapter
for which RJ-45
OL-8794-04