Table of Contents
Advertisement
Chapter 4
Configuring the Cisco PGW 2200 Softswitch Software
Text similar to the following is displayed:
M
Log in to the active host and delete the test entry using the following MML command.
Step 5
hostx mml>numan-dlt:bwhite:custgrpid="1111",svcname="testsvc",cli="9998"
Text similar to the following is displayed:
M
Log in to the standby host and start an MML session by entering mml.
Step 6
Step 7
Enter the following MML command to verify that the entry you deleted in Step 5 was also deleted in the
database on the standby host.
hosty mml>numan-rtrv:bwhite:custgrpid="1111",svcname="testsvc",cli="9998"
Text similar to the following is displayed:
M
Troubleshooting the Main Memory Database Replication
If you have problems during replication, try stopping and restarting the replication as follows:
Step 1
Stop the replication by entering:
# /etc/init.d/ttreplic stop
Step 2
Restart the replication by entering:
# /etc/init.d/ttreplic start
Displaying the Main Memory Database Replication Status
The script replication_status.sh displays the status of the MMDB replication, if it is configured.
Run the script by typing the following command:
% ./replication_status.sh
The output shows the following replication status:
Peer name
----------------
OL-18083-14
MGC-01 - Media Gateway Controller 2009-10-19 07:48:24.128 CST
RTRV
"session=ver20091019:bwhite"
/* The cli :9998: exists. */
;
MGC-01 - Media Gateway Controller 2009-10-19 08:03:22.994 CST
COMPLD
"bwhite"
;
MGC-01 - Media Gateway Controller 2009-10-19 08:04:19.391 CST
RTRV
"session=ver20091019:bwhite"
/* The cli :9998: does not exists.
;
Host name
------------------------ ------
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
Initializing the Call Screening Database
*/
Port
State
Proto
------- -----
4-93
Advertisement
Table of Contents
