Table of Contents
Advertisement
License Installation
•
License Installation
Before you begin installation, obtain and install a Cisco PGW 2200 Softswitch license file using the
instructions provided in
Recording System Data
When you upgrade to Sun Solaris 10, you must reenter various elements of your system data, because
the installation overwrites your existing system data. To ensure that you have all of your system data,
record the contents of the following files:
•
•
•
•
•
•
•
•
•
•
•
•
Note
You may have already recorded some of this information based on the
Information" section on page 1-3
Migration Overview
In order to migrate to Release 9.8 of the Cisco PGW 2200 Softswitch software, you need to install the
software on both the active and standby Cisco PGW 2200 Softswitch hosts.
During the migration procedure, you must set each host to both active and standby. For clarity, the
Cisco PGW 2200 Softswitches are labeled PGW 1 and PGW 2. PGW host 1 is the host that is active at
the beginning of the procedure, and PGW host 2 is the host that is set to standby at the beginning of the
procedure.
Cisco PGW 2200 Softswitch Release 9.8 Software Installation and Configuration Guide
5-4
Cisco Installation CD, which includes the new release of the Cisco PGW 2200 Softswitch software.
For information on latest patches, see the Release Notes for the Cisco PGW 2200 Softswitch
Release 9.8(1) at
http://www.cisco.com/en/US/docs/voice_ip_comm/pgw/9/release/note/rn981.html
"Installing the License File, page
/etc/default
/etc/defaultrouter
Hostname files for each interface (such as /etc/hostname.hme0 or /etc/hostname.bge0)
/etc/hosts.equiv
/etc/group
/etc/nsswitch.conf
/etc/passwd
/etc/resolv.conf
/etc/shadow
/etc/inet/hosts
/etc/inet/netmasks
/etc/inet/ntp.conf
Chapter 5
Migrating to Solaris 10 and Cisco PGW 2200 Softswitch Software Release 9.8
and the
"Required Machine-Specific Information" section on page
3-16".
"Required Site-Specific
1-3.
OL-18083-14
Advertisement
Table of Contents
