Installing The Starter Rope - Yamaha F25C Service Manual

3. Install the drive pawls 4.
4. Install the spring 5 and drive plate 6,
and then tighten the bolt 7 to the speci-
fied torque.
7
4
Sheave drum bolt 7:
15 N·m (1.5 kgf·m, 11.1 ft·lb)

Installing the starter rope

1. Tie a knot on the end of the starter rope.
NOTE:
Tie a knot at the end of the starter rope as
shown in the illustration.
2. Wind the sheave drum 1 counterclock-
wise until it stops.
6D55F11
6
5
4
S6D55360
3. Turn the sheave drum clockwise until the
rope hole a and manual starter roller b
are aligned. Hold the sheave drum in this
position.
NOTE:
If the sheave drum is turned less than 90°
(from where if stopped to where the rope hole
and roller align), turn it one full turn clockwise
until the hole and roller align again.
4. Pass the starter rope 2 through the rope
hole in the sheave drum and out through
the manual starter case 3, and then
install the starter rope to the manual
starter handle 4.
NOTE:
Be sure to leave 12–20 mm (0.47–0.79 in) at
the end c of the starter rope.
Power unit
1
2
3
4
5
6
7
8
9
5-14