Installing The Clamp Brackets - Yamaha F25C Service Manual

BRKT
5. Install the screw G to the tilt lever E,
and then install the circlip H to the pin
B.
G
E
NOTE:
After installation, check the tilt lock lever for
proper operation.
Tilt lever screw:
4 N·m (0.4 kgf·m, 3.0 ft·lb)

Installing the clamp brackets

1. Install the bushings, tilt stopper plates,
and pins to the swivel bracket assembly.
2. Assemble the clamp brackets, washers,
and swivel bracket, and then install the
through tube.
3. Install the plate, tighten the self-locking
nuts 1 to the specified torque, and then
tighten the cap nuts.
4. Install the tilt stopper plate bolts and tilt
stopper plate nuts, and then tighten the
nuts to the specified torque.
5. Install the collar 2 and clamp bracket
bolt 3, and then tighten the clamp
bracket nut 4 to the specified torque.
7-17
Bracket unit
H
B
S6D57220
Tilt stopper plate nut:
24 N·m (2.4 kgf·m, 17.7 ft·lb)
Self-locking nut 1:
45 N·m (4.5 kgf·m, 33.2 ft·lb)
Clamp bracket nut 4:
8 N·m (0.8 kgf·m, 5.9 ft·lb)
6. Apply water resistant grease to the
grease nipples.
NOTE:
Apply the grease until it comes out of the
bushings a.
6D55F11